Skip to content
  • There are no suggestions because the search field is empty.

Enabling Capture+ validation

Loqate Capture+ validation replaces the GB Group Matchcode validation service, which retires on 30 June 2025.  Capture+ validation is available in our Go platform and G360, which you will need to enable, following the instructions below.

Enabling Capture+ validation for Go

  1. Login to Operator
  2. Navigate to Configuration - Configure module
  3. Search for Capture+
  4. Update the Capture+ Auth Key and Validation Provider settings

The current settings you will see are:

Update these with the following:

    • Enter your Loqate Capture+ Key (you will receive a 16 character key when you activate your Loqate account)
    • Change the Validation Provider to capture+
    • Save your changes

Note that the key XXXX-XXXX-XXXX-XXXX shown above is for illustration purposes. Please enter your valid LIVE Loqate Capture+ Key, which you will receive when activating your Loqate account, into this section. If in doubt, please reach out to your GBG Loqate partner.

 

Enabling Capture+ validation for G360

  1. Login to G360
  2. Open the GMC module
  3. Navigate to Configuration Manager - Configuration - Gladstone360 Front Of House - Identity Validation
  4. Ensure Capture+ Enabled is ticked and enter your Capture+ Key

 

The current settings you will see are:

 

Update these with the following:

    • Tick Capture+ Enabled
    • Enter your Loqate Capture+ Key (you will receive a 16 character key when you activate your Loqate account)
    • Save your changes

Note that the key XXXX-XXXX-XXXX-XXXX shown above is for illustration purposes. Please enter your valid LIVE Loqate Capture+ Key, which you will receive when activating your Loqate account, into this section. If in doubt, please reach out to your GBG Loqate partner.