How to Connect a T650P via a Full Feature Base
Problem
Users need to connect a T650P Android PED to a network using a Full Feature Base and a wired ethernet connection, instead of Wi‑Fi. This connection method is required to set up the device for use with Gladstone360.
Resolution
Connect the Network Cables
- Ensure a cable is connected from the network wall point.
- Connect the ethernet cable to the network port on the rear of the Full Feature Base.
- Important: Make sure you use the correct ethernet port on the base.
Connect Power to the Base
- Connect the supplied DC power adapter to the power input on the side of the base.
- Plug the power adapter into the mains power outlet and switch on the power.
- Wait a few seconds for the base to power up.
Pair the T650P to the Base using Bluetooth
- Open the Base Control app on the T650P Android PED.
- Select the Pair A New Dock option.
- The device will display a picture of a base and the message “Put terminal into dock”.
- Place the T650P onto the base. After a few seconds, the device will display the message “Pairing…”.
- After a few more seconds, the device will display “Pairing Complete”.
- A blue light will be visible by the power connector.
Reboot the T650P
- Lift the T650P from the base.
- Press and hold the power button on the side of the device until the restart options appear on screen.
- Select Restart. The device will reboot and reconnect to the base, ready for use.
Notes
Troubleshooting:
- If the device does not pair with the base, ensure the T650P is seated correctly on the base and that the base is powered on before trying again.
- If there is no blue light visible on the base, check that the power adapter is connected correctly and the mains power outlet is switched on.
Related Articles:
- For Verifone’s full feature base instructions, see: Verifone device installation guides